Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
Remove the transfer case assembly.
Refer to: Transfer Case - V6 S/C 3.0L Petrol/INGENIUM I4 2.0L Diesel .
Using a center punch and hammer, pierce a hole in the seal at the 12 O'clock position.
Screw a 2.5 x 15 mm self-tapping screw, a maximum of 2 turns into the input shaft seal and remove the seal using a suitable tool.

Clean the seal register and thoroughly inspect for damage.