Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
Disconnect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .
Drain the cooling system.
Refer to: Cooling System Partial Draining and Vacuum Filling .
Remove the generator.
Refer to: Generator .
- Disconnect the electrical connector.
- Inspect the seal. Replace if damaged.

Remove the block heater.