LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2018 >> F-Pace Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Accessory Drive - V6 S/C 3.0L Petrol -- XE (X760)) >> Accessory Drive - V6 S/C 3.0L Petrol >> Diagnosis And Testing >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If the engine is run without the drive belt(s) connected to eliminate driven components, diagnostic trouble codes, (DTCs) may be set which must be cleared before the vehicle is returned to the owner. The engine should not be run for more than 2-3 minutes with the belts disconnected. Failure to follow this instruction may result in damage to the vehicle
SYMPTOM POSSIBLE CAUSES ACTION
Noise
  • Accessory drive belt condition and tension
  • Pulleys misaligned
  • Driven components (including tensioners)
  • Check the integrity of the accessory drive belt. Rectify as necessary
  • Check the alignment of the accessory drive belt pulleys. Rectify as necessary
  • Check the integrity of the driven components. Rectify as necessary
Accessory drive belt does not hold tension
  • Accessory drive belt wear
  • Belt tensioner failure
  • Check the integrity of the accessory drive belt. Rectify as necessary
  • Check the integrity of the belt tensioner. Rectify as necessary
scientia non olet · About LEMON Manuals