LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2018 >> E-Pace First Edition >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels & Tires -- E-Pace/X540 >> Wheels And Tires (G2704397) >> Removal And Installation >> Tire Pressure Monitor Module (G2163964) >> Installation

Tire Pressure Monitor Module (G2163964): Installation

  1. NOTE: Make sure that all the clips are correctly installed.
    • Install the tire pressure monitor module.
    • Connect the electrical connector.
    • Install the 2 sun visors on both sides.
    • Connect the 2 electrical connectors.
    • Install the 2 tapes on both sides.
  3. NOTE: Make sure that all the clips are correctly installed.

    Install the headliner front section.

    • Install the sun visor brackets on both sides.
    • Install and tighten the 2 screws.

      Torque  : 6 Nm 

    • Close the 2 sun visor bracket covers.
  5. NOTE: An audible clicks are heard when the sun visors are fully located.
    • Install and tighten the 4 bolts to the sun visors.
    • Install the 2 sun visor screw covers.
    • Secure the sun visors to the brackets.
  6. Reposition the sun visors to the original position on both sides.
    • Install and tighten the 2 bolts.

      Torque  : 6 Nm 

    • Install the front airbag covers on both sides.
  8. Install the left and right A-pillar trim panels.

    Refer to: A-PILLAR TRIM PANEL .

  9. Install the front overhead console.

    Refer to: OVERHEAD CONSOLE .

scientia non olet · About LEMON Manuals