Rear Lower Control Arm (G2187519): Installation
-
- Install the captive nut.
- Install and tighten the bolt.
Torque : 5 Nm
-
- Install the 6 brackets to the rear lower control arm.
- Install and tighten the 6 bolts.
Torque : 9 Nm
- CAUTION: Make sure that new bolts are installed.
- Install the rear lower control arm.
- Install and tighten the 2 bolts.
Renew Part: Lower control arm bolt(s) Quantity: 1 .
Torque
Stage 1: 70 Nm
Stage 2: 240°
- WARNING: Make sure a new nut is installed.
Install the rear stabilizer bar link.
Renew Part: Stabilizer bar link upper nut Quantity: 1 .
Torque
Stage 1: 30 Nm
Stage 2: 60°
- Install the 2 wiring harnesses.
- Install the wiring harness.
- Install the rear coil spring.
Refer to: COIL SPRING .
-
NOTE: Using Jaguar Land Rover approved equipment, check and if necessary adjust the wheel alignment. SRO must be claimed separately.
Check the wheel alignment and adjust if required.
Refer to: WHEEL ALIGNMENT .