Timing Drive Components (G1785583): Removal

WARNING: This page is about a different car, the 2013 Jaguar XJ, 2012 Jaguar XJ, 2011 Jaguar XJ, and 2010 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Check all timing components for wear and install new components if required.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some illustrations may show the engine removed for clarity.

Disconnect the battery ground cable.
Refer to: BATTERY DISCONNECT AND CONNECT .
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: TIMING DRIVE COMPONENTS (G1785583) .
CAUTION: Only rotate the crankshaft clockwise.

Install the special tool.

Special Tool(s): JLR-303-1303
CAUTION: If the variable valve timing (VVT) units are knocked or dropped then the VVT must be replaced.

Remove the timing chain with the VVT units.
CAUTION: If the VVT is knocked or dropped then the VVT must be replaced.

Remove the timing chain with the VVT units.
CAUTION: Discard the friction washer.