LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine - V8 N/A 5.0L Petrol -- XJ/X351) >> Engine - V8 5.0L Petrol >> Removal And Installation >> Oil Cooler (G1271898) >> Removal

Oil Cooler (G1271898): Removal

WARNING: This page is about a different car, the 2013 Jaguar XJ, 2012 Jaguar XJ, 2011 Jaguar XJ, and 2010 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some illustrations may show the engine removed for clarity.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: BATTERY DISCONNECT AND CONNECT .
  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1816935) .
  4. Refer to: INTAKE MANIFOLD (G1271897) .
  5. G11285125
  6. G11285126
  7. CAUTION:
    • Be prepared to collect escaping oil.
    • Be prepared to collect escaping coolant.
    G11285127

    Torque Specifications: 13 Nm 

  8. CAUTION: Make sure that these components are installed to the noted removal position.
    NOTE: Install a new gasket.
    G11285128
  9. CAUTION:
    • Make sure that these components are installed to the noted removal position.
    • Install new o-ring seals
    G11285129
scientia non olet · About LEMON Manuals