LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine - V8 N/A 5.0L Petrol -- XJ/X351) >> Engine - V8 5.0L Petrol >> Removal And Installation >> Cylinder Head LH (G1271890) >> Removal

Cylinder Head LH (G1271890): Removal

WARNING: This page is about a different car, the 2013 Jaguar XJ, 2012 Jaguar XJ, 2011 Jaguar XJ, and 2010 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some illustrations may show the engine removed for clarity.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: BATTERY DISCONNECT AND CONNECT .
  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: CAMSHAFT LH (G1271885) .
  4. Refer to: Secondary Bulkhead Panel LH .
  5. Refer to: EXHAUST MANIFOLD LH (G1271894) .
  6. Refer to: INTAKE MANIFOLD (G1271897) .
  7. G11284951
  8. G11284952
  9. CAUTION: Discard the seal.
    NOTE: Engine shown removed for clarity.
    G11284953
  10. G11284954
  11. G11284955
  12. NOTE: Clamp the hose to minimize coolant loss.
    G11284956
  13. NOTE: Clamp the hose to minimize coolant loss.
    G11284957
  14. G11284958
  15. G11284959
  16. CAUTION: Discard the seals.
    G11284960
  17. G11284961
  18. G11284962
  19. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
    NOTE: Left-hand shown, right-hand similar.
    G11284963
  20. CAUTION: Discard the bolts.
    G11284964
    • Install the special tool.
    • Special Tool(s):  303-1492
  21. Remove the special tool.
  22. NOTE: Discard the gasket.
    G11284965
scientia non olet · About LEMON Manuals