Crankshaft Pulley (G1785731): Removal

WARNING: This page is about a different car, the 2013 Jaguar XJ, 2012 Jaguar XJ, 2011 Jaguar XJ, and 2010 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some illustrations may show the engine removed for clarity.

Disconnect the battery ground cable.
Refer to: BATTERY DISCONNECT AND CONNECT .
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to:RADIATOR - V8 5.0L PETROL (G1269161) .
Refer to: STARTER MOTOR (G1279231) .
- Install the special tool.
- Special Tool(s): JLR-303-1304
Install the special tool.

Special Tool(s): 303-1438, 303-1437
Torque Specifications: 25 Nm
Support the special tool using a suitable vehicle stand.
NOTE: The crankshaft pulley bolt will be very tight.
Remove the special tools.
NOTE: Discard the bolt after removal.
Install the special tool.

Special Tool(s): 303-1440
Install the special tool.

Special Tool(s): 303-1441
Install the special tool.

Special Tool(s): 303-1439
CAUTION: Discard the friction washer after removing the crankshaft pulley.

NOTE: Make sure to clean the threads in the end of the crankshaft and that the crank nose is free of any foreign materials.