Rear Coolant Manifold (G2368812): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be prepared to collect escaping coolant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift. Refer to JACKING AND LIFTING .
Partially drain the cooling system. Refer to COOLING SYSTEM DRAINING AND VACUUM FILLING (G1269230) .
Remove the secondary bulkhead right panel. Refer to SECONDARY BULKHEAD PANEL RH (G1872491) .
Remove the secondary bulkhead left panel. Refer to SECONDARY BULKHEAD PANEL LH (G1267456) .
Release the vacuum pipe from the clip.
- Remove the 2 bolts.
- Reposition the wiring harness away from the rear coolant maifold.
Remove the bolt from the coolant hose bracket.
- Disconnect the 2 coolant hose connectors.
- Remove the rear coolant manifold right hose.
- Release the wiring harness clip.
- Remove the bolt.
- Remove the coolant hose bracket.
- Release the coolant hose clip.
- Disconnect the rear coolant manifold left hose.
- Disconnect the electrical connector.
- Release the 2 wiring harness clips from the right side of the rear coolant manifold.
Release the wiring harness clip from the left side of the rear coolant manifold.
- Remove the 6 bolts.
- Remove the rear coolant manifold
NOTE: This step is only required if new components are not installed.

Remove and discard the 2 O-ring seals.