Rear Coolant Manifold (G2368812): Installation

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This step is only required if new components are not installed.

Install 2 new O-ring seals to the rear coolant manifold.

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2 .
- Install the rear coolant manifold.
- Install and tighten the 6 bolts.
  Torque: 9 N.m
Install the wiring harness clip to the left side of the rear coolant manifold.
- Connect the electrical connector.
- Install the 2 wiring harness clips to the right side of the rear coolant manifold.
- Connect the rear coolant manifold left hose.
- Install the coolant hose clip.
- Install the coolant hose bracket.
- Install and tighten the bolt.
  Torque: 12 N.m
- Install the wiring harness clip.
- Install the rear coolant manifold right hose.
- Connect the 2 coolant hose connectors.
Install and tighten the bolt to the coolant hose bracket.
Torque: 12 N.m
- Reposition the wiring harness into the correct location.
- Install and tighten the 2 bolts.
  Torque: 9 N.m
Install the vacuum pipe to the clip.
Install the secondary bulkhead right panel.
Refer to SECONDARY BULKHEAD PANEL RH (G1872491) .
Install the secondary bulkhead left panel.
Refer to SECONDARY BULKHEAD PANEL LH (G1267456) .
Vacuum fill the coolant system.
Refer to COOLING SYSTEM DRAINING AND VACUUM FILLING (G1269230)