LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Cooling - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine Cooling - V6 S/C 3.0L Petrol >> Removal And Installation >> Coolant Pump (G1781023) >> Removal

Coolant Pump (G1781023): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Refer to: COOLING SYSTEM PARTIAL DRAINING, FILLING AND BLEEDING  (General Procedures).
  3. Refer to: ACCESSORY DRIVE BELT (Removal and Installation).
  4. G11287975
  5. G11287976

    Torque Specification: 9 Nm 

  6. G11287977
  7. G11287978

    Torque Specification: 47 Nm 

  8. WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
    CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
    G11287865

    Torque Specification: 12 Nm 

scientia non olet · About LEMON Manuals