Cooling System Draining, Filling And Bleeding (G1557006): Draining
WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: ENGINE COVER - V8 5.0L PETROL/V8 S/C 5.0L PETROL .
- Refer to: Secondary Bulkhead Panel RH (Removal and Installation).
- Refer to: Radiator Splash Shield (Removal and Installation).
-
WARNING:
- Release the cooling system pressure by slowly turning the coolant expansion tank cap a quarter of a turn. Cover the expansion tank cap with a thick cloth to prevent the possibility of scalding. Failure to follow this instruction may result in personal injury.
- Be prepared to collect escaping fluid.
CAUTION: Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure -
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
Torque Specification: 2 Nm
Torque Specification: 50 Nm
- Carry out the procedure up to step 1 in the filling section three times, filling the cooling system with clean water at the first two drains. At the third refill, use a suitable measuring tool to make sure that the cooling system maintains a 50% mix.