LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XJ/X351) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Pre Catalyst Heated Oxygen Sensor (Ho2S) (G1557452) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure the anti-seize compound does not contact the HO2S tip.
    • If accidentally dropped or knocked install a new sensor.
    • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

    To install, reverse the removal procedure.

  2. If a new unit is installed, configure using the approved diagnostic tool.
scientia non olet · About LEMON Manuals