LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XJ/X351) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Fuel Rail Pressure (FRP) Sensor (G1574258) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Make sure that all openings are sealed. Use new blanking caps.
  • Make sure that the tools and equipment are clean, free of foreign material and lubricant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: PETROL AND PETROL-ETHANOL HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to: Battery Disconnect and Connect (General Procedures).
  3. Refer to: Engine Cover - V6 S/C 3.0L Petrol (Removal and Installation).
  4. Refer to: Secondary Bulkhead Panel RH (Removal and Installation).
  5. Refer to: Fuel System Pressure Release - V6 S/C 3.0L Petrol/V8 5.0L Petrol/V8 S/C 5.0L Petrol (General Procedures).
  6. Refer to: FUEL INJECTION COMPONENT CLEANING (G1202495) (General Procedures).
  7. CAUTION: Cap the coolant pipe ends immediately to minimize coolant loss.
    G11293305
  8. G11293307
  9. CAUTION: Be prepared to collect escaping fluids.
    NOTE: During lubrication, keep the component vertically as shown.
    G11293308

    Lubricate with Molykote W15 as shown.

    Torque Specification: 38 Nm 

scientia non olet · About LEMON Manuals