LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine - V6 S/C 3.0L Petrol >> Oil Pan Extension - RWD (G1557027) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: BATTERY DISCONNECT AND CONNECT .
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: ENGINE OIL DRAINING AND FILLING (G1779627) .
  4. Refer to: CRANKSHAFT PULLEY (G1851000) .
  5. Refer to: ENGINE - RWD (G1557036) .

    Refer to: ENGINE - AWD (G1578758) .

  6. CAUTION:
    • The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
    • Make sure that no components fall off during removal.
    NOTE:
    • Make sure that the crankshaft is not rotated.
    • Make sure the crankshaft and flexplate mating faces are clean before installation.
    G11285085
  7. G11285143
  8. G11285144
  9. G11285145
  10. G11285146
  11. G11285147
  12. G11285148
  13. G11285149
  14. G11285150
  15. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11286716
  16. G11285152
  17. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11285153
  18. G11284999
  19. G11285155
  20. G11285201
  21. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    • Discard the fuel pipes.
    G11285157
  22. G11285158
  23. CAUTION: Be prepared to collect escaping fluids.
    G11285159
  24. CAUTION: Be prepared to collect escaping fluids.
    G11285160
  25. CAUTION: Be prepared to collect escaping fluids.
    G11285161
  26. G11285162
  27. G11285163
  28. CAUTION: Be prepared to collect escaping fluids.
    G11285164
  29. G11285136
  30. G11285166
  31. NOTE: Clean the components general area prior to dismantling.
    G11284855
  32. CAUTION: Discard the component.
    G11285168
  33. G11285169
  34. NOTE: Make sure to use the aluminium lug provided on the oil pan extension to lever against.
    G11285170
  35. NOTE: Do not disassemble further if the component is removed for access only.
    G11285171
scientia non olet · About LEMON Manuals