LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine - V6 S/C 3.0L Petrol >> Cylinder Head RH (G1557017) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Refer to: Battery Disconnect and Connect .
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: Secondary Bulkhead Panel RH .
  4. Refer to: EXHAUST MANIFOLD RH (G1557022) .
  5. Refer to: CAMSHAFT RH (G1557012) .
  6. G11286580
  7. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    G11284955
  8. NOTE: Clamp the hose to minimize coolant loss.
    G11286555
  9. CAUTION:
    • Discard the seals.
    • Be prepared to collect escaping coolant.
    G11286556
  10. G11284996
  11. NOTE: Remove and discard the O-ring seal.
    G11284997
  12. NOTE: Discard the gasket.
    G11284998
  13. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
    NOTE: Left-hand shown, right-hand similar.
    G11286560
  14. CAUTION: Discard the bolts.
    G11286588

    Special Tool(s):  303-1492

  15. G11286589
scientia non olet · About LEMON Manuals