Transmission And Transmission Fluid Cooler - V6 S/C 3.0L Petrol/V8 5.0L Petrol/V8 S/C 5.0L Petrol (G1451539): Installation

WARNING: This page is about a different car, the 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

Torque Specification: 5 Nm
CAUTION: Make sure that the torque converter remains in the transmission.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Raise the powertrain assembly jack and transmission assembly.
NOTE: Transmission shown removed for clarity.

Torque Specification: 48 Nm
Torque Specification: 48 Nm
Torque Specification: 48 Nm
Torque Specification: 45 Nm
Remove the transmission jack.
Torque Specification: 127 Nm
CAUTION: Only rotate the crankshaft clockwise.

NOTE: Make sure that the alignment mark is visible through the inspection hole as illustrated.

Torque Specification: 63 Nm
Torque Specification: 10 Nm
CAUTION: Install new o-ring seals

Torque Specification: 10 Nm
Exhaust system, refer to REMOVAL AND INSTALLATION (3.0L), or REMOVAL AND INSTALLATION (5.0L).
Refer to: Battery Disconnect and Connect (General Procedures).
Check and top up the cooling system as required.
Set the heater controls to HOT.
CAUTION: Observe the engine temperature warning light. If the warning light is displayed, switch off immediately and allow to cool. Failure to follow this instruction may cause damage to the vehicle.

Start the engine and allow to idle until hot air is emited at the face registers.
CAUTION: Observe the engine temperature warning light. If the warning light is displayed, switch off immediately and allow to cool. Failure to follow this instruction may cause damage to the vehicle.

Raise the engine speed to 2000 RPM and maintain at 2000 RPM until the engine cooling fan operates.
CAUTION: Switch off the engine and allow the coolant temperature to go cold.

Switch the engine off and allow to cool.
Visually check the engine and cooling system for signs of coolant leakage.
WARNING:
- When releasing the cooling system pressure, cover the coolant expansion tank cap with a thick cloth.
- Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure.
CAUTION:
- Make sure the coolant level remains above the "COLD FILL RANGE" lower level mark.
- Anti-freeze concentration must be maintained at 50%.
NOTE: When the cooling system is warm, the coolant will be approximately 10mm above the upper level mark on the expansion tank with the cap removed.

Check and top-up the coolant if required.
Refer to TRANSMISSION FLUID LEVEL CHECK (G1268838) (General Procedures).