Throttle Body (G1557479): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Refer to: INTAKE AIR DISTRIBUTION AND FILTERING - V6 S/C 3.0L PETROL -- XJ/X351 (303-12C) .
Refer to: COOLING SYSTEM PARTIAL DRAINING, FILLING AND BLEEDING (G1556999) (General Procedures).
CAUTION: Be prepared to collect escaping coolant.
NOTE:
- This step should only be carried out on vehicles pre 2015.
- Remove and discard the seals.
Renew Part: Engine coolant outlet seal.

Torque Specification: 10 Nm
NOTE:
- This step should only be carried out on vehicles from 2015 onwards.
- Remove and discard the seal.
Renew Part: Engine coolant outlet seal.

Torque Specification: 10 Nm
Torque Specification: 10 Nm
CAUTION:
- Take extra care when removing the throttle body, failure to follow this instruction may result in damage to the manifold absolute pressure and temperature (MAPT) sensor.
- Do not attempt to clean the throttle body bore, build up of deposits reduces air leakage past the throttle plate at the fully closed position.
NOTE:
- Remove and discard the gasket.
- Install a new gasket.