High Pressure Fuel Pump 1 - AWD (G1574229): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Before any work is carried out on the fuel system, ground the vehicle to earth and maintain the ground connection until the work is complete.
Do not carry out any repairs to the fuel system with the engine running. Failure to follow this instruction may result in personal injury.
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may ignite. Failure to follow these instructions may result in personal injury.
After carrying out repairs, the fuel system must be checked visually for leaks. Failure to follow these instructions may result in personal injury.
Wait at least 30 seconds after the engine stops before commencing any repair to the high-pressure fuel injection system. Failure to follow this instruction may result in personal injury.

CAUTION:

Make sure that tools and equipment are clean and free of foreign material and lubricant.
Do not allow the unions to hit the olive ends of the high-pressure fuel supply line as this may damage the ends of the high-pressure fuel supply line and allow foreign matter to enter the fuel injection system.
Do not remove the fuel rail pressure sensor from the fuel injection diverter rail.
Make sure the workshop area in which the vehicle is being worked on is as clean and as dust free as possible. Foreign matter from work on clutches, brakes or from machining or welding operations can contaminate the fuel system and may result in later malfunction.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Make sure that all openings are sealed. Use new blanking caps.

All vehicles

Refer to: FUEL SYSTEM PRESSURE RELEASE - V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (General Procedures).
Refer to: BATTERY DISCONNECT AND CONNECT (General Procedures).
Drain the engine oil.
Refer to: ENGINE OIL DRAINING AND FILLING (G1779627) (General Procedures).
Refer to: ENGINE COVER - V6 S/C 3.0L PETROL (G1267472) .
Refer to: FUEL INJECTION COMPONENT CLEANING (G1202495) .
CAUTION: Be prepared to collect escaping fluids.
WARNING: Be prepared to collect escaping fluids.
Refer to: AIR CLEANER RH (G1549757) .
CAUTION: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: Air Deflector .
Refer to: Front Halfshaft RH .
Refer to: ENGINE MOUNT RH - AWD (G1574170) .
Refer to: GENERATOR (G1557245) .

All vehicles

NOTE: Engine shown removed for clarity.
NOTE: Engine shown removed for clarity.
CAUTION:
- Be prepared to collect escaping fluids.
- Remove and discard the high-pressure fuel supply lines.
NOTE: Engine shown removed for clarity.
CAUTION: Be prepared to collect escaping fluids.
CAUTION: Be prepared to collect escaping fluids.

Loosen the Torx screws a turn each at a time.
CAUTION: Be prepared to collect escaping fluids.