LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Fuel Charging & Controls - V6 S/C 3.0L Petrol -- XJ/X351) >> Fuel Charging And Controls - V6 S/C 3.0 L Petrol >> Removal And Installation >> Fuel Rail LH (G1557477) >> Removal

Fuel Rail LH (G1557477): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that tools and equipment are clean and free of foreign material and lubricant.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: PETROL AND PETROL-ETHANOL HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to: FUEL SYSTEM PRESSURE RELEASE - V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1084829) (General Procedures).
  3. Refer to: Battery Disconnect and Connect (General Procedures).
  4. Refer to: ENGINE COVER - V6 S/C 3.0L PETROL .
  5. Refer to: Secondary Bulkhead Panel LH .
  6. Refer to: FUEL INJECTION COMPONENT CLEANING .
  7. CAUTION: Be prepared to collect escaping fluids.
    G11288194
  8. G11288195
  9. CAUTION: Be prepared to collect escaping fluids.
    G11288196
  10. CAUTION: Be prepared to collect escaping fluids.
    G11288197
  11. CAUTION: Be prepared to collect escaping fluids.
    G11288198
  12. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11286716
  13. G11293407
  14. G11293408
  15. G11293409

    Special Tool(s):  303-1450

  16. CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
    G11293410
  17. CAUTION:
    • Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    • Make sure that the special tool is held square to the fuel injector during removal.
    • Make sure that all open ports are covered to prevent any foreign material ingress.
    NOTE: RH illustration shown, LH is similar.
    G11288041

    Special Tool(s):  310-197

  18. CAUTION:
    • If the fuel injector is being removed without a new component being installed, the fuel injector clamp must remain with the fuel injector it is removed with.
    • If new fuel injectors are installed, a new injector clamp must be installed.
    G11288042
  19. CAUTION:
    • Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    • Do not cut the Teflon seal to deep as damage could occur to the fuel injector.
    • Pinch the Teflon seal to allow the tool to cut the Teflon seal without damaging the fuel injector.
    G11288043
  20. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
    G11288044
scientia non olet · About LEMON Manuals