High Pressure Fuel Pump 2: Removal

CAUTION: Make sure that tools and equipment are clean, free of foreign material and lubricant.

NOTE:

Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.

Refer to: PETROL AND PETROL-ETHANOL HEALTH AND SAFETY PRECAUTIONS .
Refer to:FUEL SYSTEM PRESSURE RELEASE - GTDI 2.0L PETROL/V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1084829) .
Refer to: BATTERY DISCONNECT AND CONNECT .
Refer to: ENGINE COVER - V8 5.0L PETROL/V8 S/C 5.0L PETROL .
Refer to: ENGINE OIL DRAINING AND FILLING .
Refer to: FUEL INJECTION COMPONENT CLEANING .
CAUTION: Be prepared to collect escaping fluids.
Refer to: AIR CLEANER RH .
CAUTION:
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
CAUTION:
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: ENGINE MOUNT RH .
Refer to: GENERATOR - V8 S/C 5.0L PETROL .
NOTE: Engine shown removed for clarity.
NOTE: Engine shown removed for clarity.
NOTE: Engine shown removed for clarity.
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
CAUTION:
- Remove and discard the high-pressure fuel supply lines.
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
NOTE: Engine shown removed for clarity.
CAUTION: Be prepared to collect escaping fluids.

Loosen the Torx screws a turn each at a time.
CAUTION: Be prepared to collect escaping fluids.