LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace S >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Engine Cooling - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine Cooling - V6 S/C 3.0L Petrol >> Coolant Pump >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coolant pump using new seals.
    CAUTION:
    • Make sure that the gaskets are correctly located.
    • Install all the bolts finger tight before final tightening.

    Renew Part: Engine coolant pump gasket. 

    Renew Part: Oil cooler to water pump O-ring seals. 

    Torque Specification: 12 Nm 

  2. Install the accessory drive belt tensioner.

    Torque Specification: 47 Nm 

  3. Secure the clip and the coolant hose from the coolant pump.
  4. Install the thermostat bolt.

    Torque Specification: 9 Nm 

  5. Install the coolant hose into the coolant pump.
  6. Install the accessory drive belt.

    Refer to: Accessory Drive Belt .

  7. Fill the coolant system.

    Refer to: Cooling System Draining and Vacuum Filling .

scientia non olet · About LEMON Manuals