Engine Cooling - INGENIUM I4 2.0L Diesel: Specifications
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Coolant must be collected into a clean container and can be reused if not contaminated.
LUBRICANTS, FLUIDS, SEALERS AND ADHESIVES
| ITEM | SPECIFICATION |
|---|---|
| Coolant | Texaco Extended Life Coolant (XLC) or any glycol based anti-freeze containing no methanol with only Organic Acid Technology (OAT) corrosion inhibitors |
| Coolant concentration - Will provide frost protection to -40°C (-40°F) | 50% (+10%/-0%) |
| Specific gravity of coolant at 20°C (68°F), to protect against frost down to -40°C (-40°F) | 1.068 |
| Amount of anti-freeze to use for 50% concentration: | 5.5 liters |
Capacities
| ITEM | CAPACITY (LITERS/PINTS/US QUARTS) |
|---|---|
| Cooling system capacity | 11.2/19.7/11.8 |
GENERAL SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Cooling fan | 400 W |
| Cooling system type | Pressurized, thermostatically controlled with remote header tank |
| Expansion tank | Pressurised with integrated level sensor |
| Pressure cap rating | 140 kPa |
| Radiator | Crossflow 27 mm core with integrated drain plug |
| Thermostat | Wax element (heated) |
| Starts to open | 95 °C (203 °F) |
| Fully open | 108 °C (226 °F) |
TORQUE SPECIFICATIONS
| DESCRIPTION | NM | LB-FT |
|---|---|---|
| Coolant expansion tank bolt | 7 | 7 |
| Coolant pump bolts | 12 | 9 |
| Coolant pump pulley bolts | 25 | 18 |
| Thermostat housing bolts | 12 | 9 |
| Radiator upper support bracket bolts | 9 | 7 |
| Radiator lower support bracket bolts | 9 | 7 |
| Auxiliary radiator mounting bolts | 9 | 7 |