LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace S >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Engine Cooling - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine Cooling - INGENIUM I4 2.0L Diesel >> Description And Operation >> Operation >> Active Grille Air Shutter - If Equipped >> Jet Wash Mode

Jet Wash Mode

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Jet wash mode allows the motor to fully open the vanes and then power down so that the radiator can be cleaned.

To activate jet wash mode:

  1. Start the engine.
  2. 2 Stop the engine and turn the ignition off.
  3. 3 Turn the ignition on (do not start the engine).
  4. 4 Select JaguarDrive Switchpack (JDS) 'Dynamic' mode.
  5. 5 Turn the ignition off.

This sequence prevents to enter jet wash mode accidentally when the ignition is turned off in 'Dynamic' mode.

The vanes will default to fully open whether the calibration has been completed or not. (See calibration mode section above)

Once the position feedback shows that the vanes are fully open, the motor will indicate to the PCM that it is ready to power down.

scientia non olet · About LEMON Manuals