Description And Operation: Operation: Service

Functional Test 

The Electric Park Brake (EPB) incorporates a vehicle inspection mode that allows a functional test of the park brake to be done on a rolling brake tester. For additional information, refer to: Electronic Parking Brake Service Mode Activation And Deactivation 

Brake Pad Replacement 

To change the rear brake pads it is necessary to fully retract the ball screw drive to allow retraction of the caliper piston. This can be done using one of the following methods:

• Put the Anti-lock Brake System (ABS) into the maintenance mode using Jaguar-approved diagnostic equipment
• Put the ABS control module into the maintenance mode without diagnostic equipment
• Remove the actuators from the calipers