LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace S >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake & Actuation - F-Pace >> Parking Brake And Actuation >> Electronic Parking Service Mode Activation And Deactivation >> General Procedures >> Deactivation

General Procedures: Deactivation

CAUTION: This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON (the engine must be OFF) and the parking brake system in service mode.
  1. 7. Pull and hold the parking brake switch in the apply position.
  2. 8. Wait one second.
  3. 9. Press and hold the accelerator pedal in the wide open throttle position.
  4. 10. Wait one second.
  5. 11. Set the ignition OFF and back ON immediately.
    CAUTION: Make sure that the ignition remains ON until the operation is fully completed, otherwise U3000 48 diagnostic trouble code (DTC) will be logged in the antilock brake system (ABS) control module. In order to clear this DTC, run the vehicle reset application on Jaguar approved diagnostic equipment and at the end of the application choose Yes  to clear all DTCs.
  6. 12.
    NOTE:
    • An audible noise will be heard to confirm that the parking brake has been released from the service mode
    • The parking brake is fully released from service mode when the calipers finish actuating and return to the normal released position, and the message is no longer displayed.

    Release the accelerator pedal and release the parking brake switch to the neutral position.

    CAUTION: Make sure that the ignition remains ON until the operation is fully completed, otherwise U3000 48 diagnostic trouble code (DTC) will be logged in the antilock brake system (ABS) control module. In order to clear this DTC, run the vehicle reset application on Jaguar approved diagnostic equipment and at the end of the application choose Yes  to clear all DTCs.
scientia non olet · About LEMON Manuals