General Procedures: Deactivation
WARNING:
Chock the wheels and make sure that all personnel are clear of the vehicle before carrying out the following procedure.
NOTE:
- To be carried out in the event that the vehicle has no electrical power.
- Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable.
Refer to: Battery Disconnect And Connect
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: Wheel And Tire Removal and Installation
- CAUTION: Discard the bolt.NOTE: Remove and discard the O-ring seal.
Renew Part: Electric park brake actuator fitting kit.
Torque Specification: 8 Nm
- Repeat the above procedure for the other side.