LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace First Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Fuel Charging & Controls - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Fuel Charging And Controls - INGENIUM I4 2.0L Petrol >> High Pressure Fuel Pump (G2043272) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Extreme cleanliness must be exercised when handling these components. Make sure that all tools and the surrounding area is clean before commencing work.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustration showing certain components removed to provide extra clarity.
  1. Before working on the fuel system make sure to study the fuel system health and safety service information.

    Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions .

  2. Release the fuel pressure.

    Refer to: Fuel System Pressure Release (General Procedures).

  3. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect (General Procedures).

  4. Remove the engine cover.
    G11445075
  5. G11307914

    Remove the Noise, Vibration and Harshness (NVH) material.

  6. CAUTION: Discard the clips if damaged or worn.
    G11307916

    Release the coolant hose and wiring harness clips.

  7. G11307917

    Disconnect the High Pressure (HP) fuel pump electrical connector.

  8. G11307918

    Remove the engine lifting eye.

  9. G11307919

    Disconnect and reposition the engine wiring harness.

  10. Clean all the fuel tube unions and the surrounding area before working on the fuel system.

    Refer to: FUEL INJECTION COMPONENT CLEANING .

  11. WARNING: Be prepared to collect escaping fuel.
    CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
    G11307948

    Remove the 2 fuel tubes.

  12. CAUTION: Loosen each of the bolts half a turn at a time until the spring tension is fully released.
    G11307949

    Remove the HP fuel pump. Discard the bolts.

  13. G11307950

    Remove and discard the HP fuel pump O-ring seal.

  14. CAUTION: Note the orientation of the component prior to removal.
    G11307951

    Remove and inspect the HP fuel pump tappet, replace if damaged or worn.

scientia non olet · About LEMON Manuals