LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace First Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Engine - INGENIUM I4 2.0L Petrol >> Intake Manifold >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Only perform steps 1 and 2 if the components were previously removed.

    Install the throttle body. Renew the seal.

    Renew Part: Throttle body to intake manifold seal. 

  2. CAUTION: Inspect the seal and renew the component if damaged or worn.

    Install the manifold absolute pressure sensor.

    Torque Specification: 5 Nm 

  3. Install the intake manifold assembly. Renew the seals.

    Renew Part: Intake manifold seals 

    Torque Specification: 12 Nm 

  4. Connect the coolant pipe to the thermostat assembly.
  5. Install the oil level gauge

    Torque Specification: 8 Nm 

  6. Connect the charge air pipe.
  7. Connect and secure the wiring harnesses.
  8. Install the vacuum pipe.
  9. Install the purge valve.
  10. Install the lower coolant pipe.
  11. Install the upper coolant pipe.

    Torque Specification: 10 Nm 

  12. Connect the upper coolant hose.
  13. Install the breather.
  14. NOTE: If equipped.
    • Install the rear Noise, Vibration and Harshness (NVH) material.

      Torque Specification: 8 Nm 

  15. Install the front NVH material.
  16. Install the engine cover.
  17. Fill the coolant system.

    Refer to: Cooling System Partial Draining and Vacuum Filling .

  18. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  19. Lower the vehicle.
scientia non olet · About LEMON Manuals