Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
Disconnect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .
Remove the accessory drive belt.
Refer to: Accessory Drive Belt .
CAUTION: Make sure that the special tool is correctly located.

Install the special tool onto the crankshaft pulley.

Special Tool(s): JLR-303-1630
CAUTION: Discard the bolts.

Remove the 4 crankshaft pulley retaining bolts.
- Remove the crankshaft pulley special tool.
  Special Tool(s): JLR-303-1630
- Remove the crankshaft pulley.