LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace First Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (Fuel Tank & Lines - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Fuel Tank And Lines - INGENIUM I4 2.0L Petrol >> Fuel Supply Line >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure that all the O-ring seals are correctly installed before connecting the fuel supply line connectors.
    G11314839
  2. Install the fuel supply line to the vehicle.
  3. Connect the 2 fuel supply line connectors to the engine.
  4. Install the upper fuel supply line bracket to body bolt.

    Torque Specification: 7 Nm 

  5. Connect the 2 wiring harness clips to the upper fuel supply line bracket.
  6. Connect the fuel supply line to body clip.
  7. Install the fuse box if previously removed.

    Torque Specification: 7 Nm 

  8. Install the body brace and fuel supply line rubber mounting.

    Torque Specification: 55 Nm 

  9. Install the cowl vent screen.
  10. Install the windshield wiper pivot arms.

    Refer to: Windshield Wiper Pivot Arm .

  11. Raise the vehicle on the lift to an appropriate working height.
  12. Connect the 2 fuel supply line connectors to the underbody fuel lines.
  13. Install the lower fuel supply line mounting bracket nut.

    Torque Specification: 7 Nm 

  14. Install the wiring harness clip to the lower fuel supply line mounting bracket.
  15. Install the front left fender splash shield.

    Refer to: Fender Splash Shield .

  16. Lower the vehicle to the floor.
  17. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  18. Bleed the fuel system.

    Refer to: Fuel System Bleeding .

scientia non olet · About LEMON Manuals