Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
- Avoid flames, sparks or lighted substances.
- Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.
CAUTION:
Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Removal steps in this procedure may contain installation details.
All vehicles
- Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions .
- Refer to: Fuel Tank Draining .
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: Driveshaft - Ingenium I4 2.0L Petrol
,
Refer to: Driveshaft - V6 S/C 3.0L Petrol .
-
WARNING: Be prepared to collect escaping fuel.
Torque:
M8 nut 25 Nm
-
WARNING: Be prepared to collect escaping fuel.
Vehicles with fuel fired heater
-
WARNING: Be prepared to collect escaping fuel.
All vehicles
-
NOTE: Do not disassemble further if the component is removed for access only.
General Equipment: Transmission jack
Torque: 25 Nm
- Refer to: Fuel Level Sender .
Refer to: Fuel Level Sender .