DTC P0332-21: Knock Sensor 2 Circuit Low (Bank 2) - Signal amplitude < minimum: Action

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle Conditions to enable DTC Logging Strategy
- Normal driving
Check powertrain control module for related misfire DTCs and refer to this DTC index. Rectify these first
Refer to the electrical circuit diagrams and check knock sensor circuit for short circuit to ground, short circuit to power
Measure knock sensor circuit for correct resistance
- Knock sensor resistance should be greater than 4 Mega Ohms
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
Check and install a new knock sensor as required