LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace First Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Engine Cooling - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Engine Cooling - INGENIUM I4 2.0L Petrol >> Coolant Pump (G1998226) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Partially drain the cooling system.

    Refer to: Cooling System Partial Draining and Vacuum Filling .

  4. Remove the intake air resonator.

    Refer to: Intake Air Resonator .

  5. G11307369
    • Loosen the bolts, but do not fully remove.
  6. NOTE: Note the position of the accessory drive belt to aid installation.
    G11306804
    • Release the accessory drive belt tension.
    • Insert a suitable tool, where illustrated, to prevent tension being applied to the accessory belt.
  7. G11307371
    • Release the accessory belt from the pulleys, as illustrated.
  8. G11307372
    • Remove the water pump pulley.
  9. CAUTION: Make sure that the wiring harness is positioned securely to one side, to prevent it being trapped between the coolant pump and engine block when the coolant pump is installed.
    G11307373
    • Disconnect the electrical connectors.
  10. CAUTION: Be prepared to collect escaping coolant.
G11307374
scientia non olet · About LEMON Manuals