Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the coolant pump.
- Torque Specification: 12 Nm
- Connect the electrical connectors.
- Install the water pump pulley.
- Do not fully tighten at this stage.
CAUTION: Make sure that the accessory drive belt is correctly located on each pulley.
- Install the accessory drive belt.
- Release the accessory drive belt tensioner.
- Fully tighten the water pump pulley bolts.
- Torque Specification: 25 Nm
Install the intake air resonator.
Refer to: Intake Air Resonator .
- Vacuum fill the cooling system.
  Refer to: Cooling System Partial Draining and Vacuum Filling .
- Connect the startup battery ground cable.
  Refer to: Battery Disconnect and Connect .