Removal And Installation: Removal
WARNING:
- Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
- Avoid flames, sparks or lighted substances.
- Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.
CAUTION:
Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Removal steps in this procedure may contain installation details.
- Refer to: Petrol And Petrol-Ethanol Fuel Systems Health And Safety Precautions
- Refer to: Fuel System Pressure Release
- Refer to: Battery Disconnect And Connect
- Refer to: Engine Cover - V6 S/C 3.0L Petrol
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: Generator
- Refer to: Right Engine Mount
Torque Specification: 40 Nm
Torque Specifications:
M10 29 Nm
M6 11 Nm
-
WARNING: Be prepared to collect escaping fuel.CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
Torque Specification: 21 Nm
-
WARNING: Be prepared to collect escaping fuel.CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
Torque Specification: 21 Nm
Torque:
M6 11 Nm
M8 25 Nm
M5 Nut 6 Nm