LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2017 >> F-Pace First Edition >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging And Controls - V6 S/C 3.0L Petrol - F-Pace >> Fuel Charging And Controls - V6 S/C 3.0L Petrol >> Fuel Rail Crossover Tube >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:
  • Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
  • Avoid flames, sparks or lighted substances.
  • Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.
CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  1. Refer to: Petrol And Petrol-Ethanol Fuel Systems Health And Safety Precautions
  2. Refer to: Fuel System Pressure Release
  3. Refer to: Battery Disconnect And Connect
  4. Refer to: Engine Cover - V6 S/C 3.0L Petrol
  5. G11310349
  6. G11307855
  7. G11307856

    Torque Specification: 11 Nm 

  8. WARNING: Be prepared to collect escaping fuel.
    CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
    G11307857

    Torque Specification: 21 Nm 

scientia non olet · About LEMON Manuals