Air Suspension Reservoir (G1311861): Removal
WARNING:
The air suspension is pressurised. Make sure dirt or grease does not enter the system. Always wear hand, eye and ear safety standard protection when working on the system.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: Air Suspension System Depressurize and Pressurize (General Procedures).
-
WARNING: Loosen the pipes no more than one full turn to allow the stored air pressure to vent for a minimum of three seconds.CAUTION: Using a suitable blanking plug, blank off the end of the air pipe to prevent dirt ingress.
A new air line connector must be installed.
Refer to: Air Line Connector (General Procedures).
Torque Specification: 3.5 Nm
Torque Specification: 7 Nm