LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine - V8 N/A 5.0L Petrol -- XJ/X351) >> Engine - V8 5.0L Petrol >> Removal And Installation >> Cylinder Head RH (G1271891) >> Removal

Cylinder Head RH (G1271891): Removal

WARNING: This page is about a different car, the 2013 Jaguar XJ, 2012 Jaguar XJ, 2011 Jaguar XJ, and 2010 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some illustrations may show the engine removed for clarity.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: BATTERY DISCONNECT AND CONNECT .
  2. Raise and support the vehicle.
  3. Refer to: Secondary Bulkhead Panel RH .
  4. Refer to: CAMSHAFT RH (G1271886) .
  5. Refer to: EXHAUST MANIFOLD RH (G1271895) .
  6. Refer to: INTAKE MANIFOLD (G1271897) .
  7. G11284987
  8. G11284988
  9. CAUTION:
    • Discard the seal.
    • LH illustration shown, RH is similar.
    NOTE: Engine shown removed for clarity.
    G11284953
  10. G11284990
  11. G11284991
  12. NOTE: Clamp the hose to minimize coolant loss.
    G11284956
  13. NOTE: Clamp the hose to minimize coolant loss.
    G11284957
  14. G11284958
  15. CAUTION: Discard the seals.
    G11284960
  16. G11284996
  17. NOTE: Remove and discard the O-ring seal.
    G11284997
  18. NOTE: Discard the gasket.
    G11284998
  19. G11284999
  20. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
    G11284963
  21. CAUTION: Discard the bolts.
    G11285001
  22. NOTE: Discard the gasket.
    G11285002
scientia non olet · About LEMON Manuals