LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Cooling - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine Cooling - V6 S/C 3.0L Petrol >> Removal And Installation >> Cooling Module (G1557002) >> Removal

Cooling Module (G1557002): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Refer to: AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .
  3. Refer to: COOLING SYSTEM PARTIAL DRAINING, FILLING AND BLEEDING  (General Procedures).
  4. Refer to: Air Cleaner Outlet Pipe T-Connector (Removal and Installation).

  5. Refer to: Air Cleaner LH (Removal and Installation).
  6. Refer to: Air Cleaner RH (Removal and Installation).
  7. Refer to: Air Cleaner Outlet Pipe LH (Removal and Installation).
  8. Refer to: Air Cleaner Outlet Pipe RH (Removal and Installation).
  9. G11287838
  10. G11287839
  11. G11287840
  12. G11287841
  13. CAUTION: Be prepared to collect escaping coolant.
    G11287842
  14. G11287843
  15. G11287844
  16. G11285542
  17. NOTE:
    • Remove and discard the O-rings.
    • Install new O-ring seals.
    G11287846

    Torque Specification: 8 Nm 

  18. G11285543
  19. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    G11284650

    Torque Specification: 9 Nm 

  20. G11287849
  21. G11287850
scientia non olet · About LEMON Manuals