Possible Causes
WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
- The final drive ratio is output as part of the vehicle/car configuration. If the value received by the powertrain control module does not match the internally used value this DTC will be set
- Car configuration signal not received
- Car configuration file incorrect
- Harness fault - CAN circuit