P0192-84 - Fuel Rail Pressure Sensor Circuit Low Bank 1 - Signal below allowable range: Action
WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
- Check connector is not disconnected, connector pin is not backed out
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Refer to the applicable SYSTEM WIRING DIAGRAMS and check fuel rail pressure sensor circuit for short circuit to ground
- Check fuel rail pressure sensor 5 volt power supply circuit for open circuit, high resistance
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- Check and install a new fuel rail pressure sensor as required