Exhaust System - AWD (G1576765): Removal
WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe due care when working near a hot exhaust system.
NOTE:
Removal steps in this procedure may contain installation details.
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: Air Deflector .
Torque Specification: 7 Nm
Make sure the alignment mark, on the steering gear pinion seal protection cover, is central to the steering gear pinion casting.
-
WARNING: Make sure that a new bolt is installed.
Torque Specification: 35 Nm
Torque Specification: 40 Nm
Torque Specification: 40 Nm
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.NOTE:
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
Torque Specification: 30 Nm
Torque Specifications:
Bolts 30 Nm
Nuts 10 Nm
-
NOTE: Do not disassemble further if the component is removed for access only.
Special Tool(s): 310-121
Torque Specification: 48 Nm
Torque Specification: 18 Nm