Removal And Installation: Installation

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

- Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G or Loctite 5900) to the areas shown, and tighten the bolts within 7 minutes.
- Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G or Loctite 5900) to the areas shown, and tighten the bolts within 7 minutes.
NOTE: Tighten the bolts in the indicated sequence.

Torque Specifications: 12 Nm
NOTE: Tighten the bolts in the indicated sequence.

Torque Specifications: 12 Nm
CAUTION: Make sure that the mating faces are clean and free of foreign material.

Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G or Loctite 5900) to the areas shown, and tighten the bolts within 7 minutes.
CAUTION: Make sure that the mating faces are clean and free of foreign material.

Install the bolts, but do not tighten fully at this stage.

Special Tool(s): 303-1433
NOTE: Tighten the bolts in the indicated sequence.
- Torque Specifications:
  M8 20 Nm
  
  M6 12 Nm
Remove the special tools.
Torque Specifications: 12 Nm
Torque Specifications: 12 Nm
Torque Specifications: 12 Nm
Torque Specifications: 25 Nm
Refer to: CRANKSHAFT PULLEY (G1851000) .
Refer to: VALVE COVER RH (G1557033) .
Refer to: VALVE COVER LH (G1557032) .
Refer to: THERMOSTAT HOUSING (G1557005) .
Refer to: ELECTRIC THERMOSTAT (G1772758) .
Refer to: ACCESSORY DRIVE BELT TENSIONER (G1549997) .
Refer to: ACCESSORY DRIVE BELT (G1549995) .
Refer to: BATTERY DISCONNECT AND CONNECT .