Removal And Installation: Installation

All vehicles 

1. CAUTION:

   • Make sure that the mating faces are clean and free of foreign material.
   • Make sure the anti-seize compound does not contact the catalyst monitor sensor tip.
   • If accidentally dropped or knocked install a new sensor.
   • Make sure the catalyst monitor sensor wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
   NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

   Torque Specifications: 45 Nm 

2. CAUTION: LH illustration shown, RH is similar.
   NOTE: Install the special tool.

   Install a new gasket.

   Special Tool(s):  303-1444-01

3. CAUTION: LH illustration shown, RH is similar.
   NOTE: If a new cylinder head is installed use the special tools in the illustration.

   Special Tool(s):  303-1444-02

4. CAUTION:

   • Make sure that new bolts are installed.
   • LH illustration shown, RH is similar.
   NOTE: Install the spacers in the noted position.

   Torque Specifications: 10 Nm 

5. CAUTION: LH illustration shown, RH is similar.

   Remove the special tool.

6. CAUTION:

   • Make sure that new bolts are installed.
   • LH illustration shown, RH is similar.
   NOTE: Install the spacers in the noted position.

   Torque Specifications: 10 Nm 

7. CAUTION: LH illustration shown, RH is similar.
   Fig 1: Exhaust Manifold Bolts Tightening Sequence (Left Side)

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   Torque Specifications: 18 Nm 

8. Torque Specifications: 

   Bolts 6.3 x 13 3 Nm 

   Bolt M8 25 Nm 

Right-hand drive vehicles 

1. Refer to: STEERING GEAR - RWD .

   Refer to: STEERING GEAR - AWD .

All vehicles 

1. Refer to: EXHAUST SYSTEM - RWD (G1551299) .

   Refer to: EXHAUST SYSTEM - AWD (G1576765) .

2. Refer to: BATTERY DISCONNECT AND CONNECT .