LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine - V6 S/C 3.0L Petrol >> Exhaust Manifold LH (G1557021) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.

All vehicles 

  1. Refer to: BATTERY DISCONNECT AND CONNECT .
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: EXHAUST SYSTEM - RWD (G1551299) .

    Refer to: EXHAUST SYSTEM - AWD (G1576765) .

Left-hand drive vehicles 

  1. Refer to: STEERING GEAR - RWD .

    Refer to: STEERING GEAR - AWD .

All vehicles 

  1. G11285053
  2. Refer to: POWER STEERING PUMP - V6 S/C 3.0L PETROL .
  3. NOTE: Remove and discard the O-ring seal.
    G11285054
  4. G11285028
  5. G11286656
  6. G11286657
  7. CAUTION: Discard the bolts.
    NOTE:
    • Discard the gasket.
    • Make sure that the position of the spacers is noted before removal of the manifold.
    G11286658
  8. NOTE: Do not disassemble further if the component is removed for access only.
    G11285059