Removal And Installation: Removal
WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
| 303-021 Engine support bracket |
|
| 303-1435 Engine Lifting Brackets Rear |
|
| 303-1436 Engine Lifting Bracket Front |
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some illustrations may show the engine removed for clarity.
- Refer to: BATTERY DISCONNECT AND CONNECT .
- Refer to: HOOD (Removal and Installation).
- Refer to: COOLING SYSTEM PARTIAL DRAINING, FILLING AND BLEEDING (G1556999) .
- Refer to: Secondary Bulkhead Panel RH .
- Refer to: COOLING FAN MOTOR AND SHROUD (G1557001) .
- Refer to: V6 S/C 3.0L Petrol/V8 5.0L Petrol/V8 S/C 5.0L Petrol Transmission Removal .
-
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.CAUTION: Be prepared to collect escaping fuel.
- Siphon the fluid from the power steering reservoir.
-
CAUTION: Be prepared to collect escaping fluids.
-
WARNING: Be prepared to collect escaping fluids.CAUTION: Discard the sealing washers.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
Special Tool(s): 303-1435
Torque Specifications: 25 Nm
-
CAUTION: Be prepared to collect escaping coolant.
Special Tool(s): 303-1436
Torque Specifications: 25 Nm
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: The air conditioning (A/C) system will remain fully charged during this procedure, care must be taken when positioning the assembly aside.
Remove the special tool.
Special Tool(s): 303-021
-
NOTE: This step requires the aid of another technician.
Using a suitable tool, remove the engine.
Special Tool(s): 303-1435, 303-1436