LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine - V6 S/C 3.0L Petrol -- XJ/X351) >> Engine - V6 S/C 3.0L Petrol >> Cylinder Head LH (G1557016) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Refer to: Battery Disconnect and Connect .
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: Secondary Bulkhead Panel LH .
  4. Refer to: EXHAUST MANIFOLD LH (G1557021) .
  5. Refer to: CAMSHAFT LH (G1557011) .
  6. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    G11284955
  7. NOTE: Clamp the hose to minimize coolant loss.
    G11286555
  8. CAUTION:
    • Be prepared to collect escaping coolant.
    • Discard the seals.
    G11286556
  9. G11286557
  10. G11285762
  11. G11284962
  12. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
    G11286560
  13. G11286561

    Special Tool(s):  303-1492

  14. G11286562
scientia non olet · About LEMON Manuals