LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Front Drive HALFSHAFTS -- XJ/X351) >> Front Drive HALFSHAFTS >> Removal And Installation >> Inner Constant Velocity (CV) Joint Boot (G1557131) >> Removal

Inner Constant Velocity (CV) Joint Boot (G1557131): Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • LH illustration, RH is similar.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Refer to Front Halfshaft LH - Removal .

    Refer to Front Halfshaft RH - Removal .

  3. CAUTION: Discard the retaining clips.
    G11284239
  4. CAUTION:
    • Use suitable protective covers to protect the halfshaft.
    • Make sure that the cv joint is positioned as illustrated.
    G11284240
  5. CAUTION: Using a suitable soft drift, strike the joint in the area indicated to release it from the shaft.
    G11284241
  6. CAUTION: Using a suitable soft drift, strike the component in the direction shown to allow easy release of the retaining clip.
    G11284242
  7. G11284243
  8. CAUTION: Mark the components to aid installation.
    G11284244
  9. NOTE: Clean all the mating faces and reusable parts thoroughly and check for damage.
    G11284245

    Special Tool(s):  303-D121

  10. CAUTION: Discard the component.
    G11284246
scientia non olet · About LEMON Manuals